-40%
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90

DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90

$ 633.59

Availability: 100 in stock
  • Model: E-90
  • Brand: Darex
  • Country/Region of Manufacture: United States
  • All returns accepted: ReturnsNotAccepted
  • Condition: This is a Precision Endmill Sharpener w/ 5C Air Spindle. There are a couple things that need to be noted, there is a small crack on the rear of the motor housing as can be seen in the last picture, also when powering on the unit there is a bit of a screech that comes from the wheel spindle, sounds like the bearings might be dry, but I cannot say for sure what the issue is. Other than that, the unit appears fine and was in operation when we acquired it. Thank you.

    Description

    Made in the USA by Darex Corp.
    This is a Precision Endmill Sharpener w/ 5C Air Spindle. There are a couple things that need to be noted, there is a small crack on the rear of the motor housing as can be seen in the last picture, also when powering on the unit there is a bit of a screech that comes from the wheel spindle, sounds like the bearings might be dry, but I cannot say for sure what the issue is. Other than that, the unit appears fine and was in operation when we acquired it. Thank you.
    Model #: E-90
    Serial #: 92308
    SPECIFICATIONS:
    Spindle Taper: 5C
    Cutter Diameter Range: 1/16" to 2"
    Shank Diameter Range: 3/16" to 1"
    Motor: 1/4 Horsepower, 115 Volt, 3.2 Amp, 2,800 / 3,400 RPM, 50/60 Hz, Single Phase
    Electrical: 115 Volt, Single Phase
    Overall Dimensions: 22" x 18" x 11" high
    Comes exactly as shown in pictures.
    LOCAL PICKUP AVAILABLE @ 1520-A INDUSTRIAL PARK ST. COVINA, CA 91722.
    HABLAMOS ESPAÑOL.